SH MonsterArts Discussion ( + related military vehicles)

[Timz]

[Dr Kain]

[ebirahsmeg1]

I’m not taking a bunch of fancy pictures right now, as it’s past 2:00 am over here and I worked 12 hours today, so I need to get some rest, so I apologise for the rather barebones review. But here’s a quick run down:





Well, when I opened it, the mouth of KG’s middle head *immediately* fell off, then his entire first neck joint fell off after barely touching it. The lower jaws on the other two heads don’t seem to have this issue, but the middle head’s jaw is so flimsy that I can barely touch it without its jaw falling off, thus ruining any pose-ability of the middle head’s mouth. I've never had this issue with any of my other MA figures (not even Rodan), and I am not exaggerating...I could probably sneeze on it and it would fall off. Wonderful. The left head’s lower neck joints are also very flimsy and fall apart when trying to pose it the bottom section of the neck. Again, these issues may not occur on everyone’s figure (God I hope not)...but my worst QC fears are coming true so far, and it’s frustrating as hell. As far as the “over-biteâ€

[Dr Kain]

Oh you mother ****er!!! You just had to show a pic of them all together. Now I want those dammit, and I cannot afford them. I cannot even afford to catch up on my One Piece and Kamen Riders right now, and those are half the price of one of those.

[ebirahsmeg1]

Please go away...

[sachiel]

[canofhumdingers]

[emeGoji]

[ebirahsmeg1]

[MekaGojira3k]

[sachiel]

[Legion]

[king_ghidorah]

[MekaGojira3k]

[Legion]

[MekaGojira3k]

[sachiel]

[Dr Kain]

[MekaGojira3k]

[burninggoji]

[quote="ebirahsmeg1"]I’m not taking a bunch of fancy pictures right now, as it’s past 2:00 am over here and I worked 12 hours today, so I need to get some rest, so I apologise for the rather barebones review. But here’s a quick run down:





Well, when I opened it, the mouth of KG’s middle head *immediately* fell off, then his entire first neck joint fell off after barely touching it. The lower jaws on the other two heads don’t seem to have this issue, but the middle head’s jaw is so flimsy that I can barely touch it without its jaw falling off, thus ruining any pose-ability of the middle head’s mouth. I've never had this issue with any of my other MA figures (not even Rodan), and I am not exaggerating...I could probably sneeze on it and it would fall off. Wonderful. The left head’s lower neck joints are also very flimsy and fall apart when trying to pose it the bottom section of the neck. Again, these issues may not occur on everyone’s figure (God I hope not)...but my worst QC fears are coming true so far, and it’s frustrating as hell. As far as the “over-biteâ€

[Shin_Edda_Robo!!!!!]

The issue of nail polish on ball joints goes all the way back to when Ball Joints were introduced back during the time of Transformers Generation 2.

Loose ball joints happen sometimes, and there's no way around it unless nail polish is used to create more friction.

Destoroyah's going to be $200? Craziness. But I've seen worse. I doubt it's going to top $150.

[Timz]

What Marmits are better in articulation than this line? Saw it posted a couple of times, but for those who don't know all those particulars, are there some examples you can point to? This is not for a debate, just general curiosity since it was mentioned.

[sachiel]

[Baltan II]

[MekaGojira3k]